Follow these steps to configure your Logitech Mevo 2.0 App with sidelineHD .
Download Mevo 2.0 App
Setup Mevo 2.0 App
-
Power up your Mevo device by pressing and holding the power button for three seconds. The white LED lights will pop on and then start blinking as it initializes.
-
Navigate to the streaming section for your team. From your team page go to Settings > Stream Settings > Streaming Publishing.
-
Click the Mevo button to add a new camera or select the three dots to the right of your camera set-up, followed by the Reconfigure Camera button.
-
Click Open in Mevo App button.
-
Click the Pair with Mevo button.
NOTE: If you're a first time user you will get many prompts for approval. Make sure you click yes, agree, install, download etc. when prompted.
-
After a successful setup with the Logitech Mevo 2.0 App you'll see this screen. Click the blue LAUNCH MEVO APP button.
Livestream With Mevo 2.0 App
-
Toggle to select either Wi-Fi or Cellular Data:
-
If you have a stand alone Hotspot / MiFi, or plan to use a personal hotspot from a different cell phone, select Wi-Fi.
-
To use your phone’s data plan, select Cellular Data.
-
-
If you selected Wi-Fi: Click on STREAM VIA Wi-Fi. You will be prompted to locate and click on your Wi-Fi network. Click JOIN on any pop up menus.
-
If you selected Cellular Data: Click on STREAM VIA CELLULAR DATA. Click JOIN on any pop up menus.
-
To go live, push the RED button on the bottom left hand corner.
-
Follow these steps to go live (the steps are noted in the picture below):
-
Select RTMP (Do not select Facebook or YouTube).
-
Choose the sidelineHD logo.
-
Set resolution to 720p or lower.
-
Press the GO LIVE button.
If everything is working correctly, you should receive an UP text message from sidelineHD within 30 seconds.
TIP: If you get repeated up/down messages, it's likely because your connection does not have enough bandwidth. Downshift to 480p or 360p (#3 in the picture above) to save your livestream.
Comments
0 comments
Article is closed for comments.